(the 2 Danos and the DOD are going to be left off the board)
I like the"amp cooking" application of the Launch Pad, but I'm open to suggestions on how to route these pedals. Ignore the chorus pedal, it may also be coming off the board. Just the Barber's are what I'm looking for suggestions on.
Just some info that may help..
I'll be using the pedals with an Epiphone Valve Jr head. Only mod to the head is the jumper labeled JP1 has been clipped, which brightens the amp up.(not ice pick bright) Eminence speaker in the Epi VJ cab has been replaced w/a '59 alnico 12" I pulled from a "59 RCA console phonograph. Also put a Motorola 12AX7 and an RCA 6BQ5 in it, again, pulled from old consoles.
I play and write mostly alt-country stuff, and will be using a strat with super low output pups as my main guitar. (4.3 k, 4.3 k,5.0 k)
So, assuming I won't be using a loop box, how would you line them up ? I know I can switch them around and see what I like, but I'd like to ask for suggestions as a starting point.
Oh, also, if I use a volume pedal, where should it go ? Before the pedal board or somewhere in the middle ?
tia