Direct Drive mod question

Discuss internal affairs of pedals, guitars, amps and components etc...
Not focused on DIY.

Direct Drive mod question

Postby Headbush » Mon Nov 23, 2015 4:14 pm

Hello everyone, I am new to the forum, but not to the barber pedals!

I've been using DD over the past 3 years which I really like , but as I changed some of my gear I consider I need to modify it a little :D . It has the Bass and Presence trims but I need to add a pot(or trimmer) for the Mids as well and what's most important to me is affecting the LOW Cut Circuit, as I think the pedal needs more lows for my setup. I've read about DEEP BASS MODE, but first of all I can't find the tweaks page , and second I am not sure if it was not a mod only for the first DD :?: , that had no trimmers inside.

So to make it short, I would like to know, which caps and resistors to change so that I can open the low end more, and where can i put trimmer so that I can control the mids.

Thank you !
Eric Johnson Signature Strat / Line 6 Relay G50 / N-Audio A\B Booster / KORG Pitch Black / Barber Direct Drive / Blackstar HT Dist / Wampler Ego Comp/ MXR KFK EQ / MXR Microamp / BOSS RE-20 space echo / Tri Reverb / ENGL SCREAMER
Headbush
 
Posts: 1
Joined: Thu Nov 12, 2015 5:56 am

Return to Nuts and Bolts

Who is online

Users browsing this forum: No registered users and 2 guests