Direct Drive mod question
Posted: Mon Nov 23, 2015 4:14 pmHello everyone, I am new to the forum, but not to the barber pedals!
I've been using DD over the past 3 years which I really like , but as I changed some of my gear I consider I need to modify it a little
. It has the Bass and Presence trims but I need to add a pot(or trimmer) for the Mids as well and what's most important to me is affecting the LOW Cut Circuit, as I think the pedal needs more lows for my setup. I've read about DEEP BASS MODE, but first of all I can't find the tweaks page , and second I am not sure if it was not a mod only for the first DD 
, that had no trimmers inside.
So to make it short, I would like to know, which caps and resistors to change so that I can open the low end more, and where can i put trimmer so that I can control the mids.
Thank you !
I've been using DD over the past 3 years which I really like , but as I changed some of my gear I consider I need to modify it a little
. It has the Bass and Presence trims but I need to add a pot(or trimmer) for the Mids as well and what's most important to me is affecting the LOW Cut Circuit, as I think the pedal needs more lows for my setup. I've read about DEEP BASS MODE, but first of all I can't find the tweaks page , and second I am not sure if it was not a mod only for the first DD , that had no trimmers inside.So to make it short, I would like to know, which caps and resistors to change so that I can open the low end more, and where can i put trimmer so that I can control the mids.
Thank you !